Document Details |
|
Name of Department/Committee : | MTD 15 |
---|---|
Document Number : | MTD 15 ( 23765) |
Document Title [English] : | Refractory test-piece preparation Gunning refractory panels by wet gunning techniques |
Document Title [Hindi] : | ABD |
Document Type : | New |
Language : | English |
Priority : | 3 |
ICS Code : | ICS 81.080 |
Date of Project Approval : | 20-06-2023 |
Standards to be Superseded : |
Classification Details |
|
Group : | Metals, Alloys and Metal Products (including Steel Products) |
Sub Group : | Refractory products |
Sub Sub Group : | Code of practice, sampling on refractory |
Aspects : | Code of Practice |
Risk : | None |
Certification : | Not Certifiable |
Short Commom Man's Title : | Refractory test-piece preparation of Gunning refractory panels by wet gunning techniques |
ITCHS Code : | |
Ministry : | |
Sustainable development Goals : | |
Degree of Equivalence : | Identical under dual numbering |
Identical/Equivalent Standards : | ISO 18886:2016 |
Organization Type: | ISO |
Sl.No. | Synosis Points | |
1 | This Draft Indian Standard specifies the procedures for the preparation of test pieces from refractory materials by wet gunning at ambient temperatures. The test pieces are for the determination of properties on wet-gunned products prepared under either “standard conditions” (as required for quality assurance or product development) or “site conditions. In the case of “site conditions”, the purpose of the testing is to establish the properties pertaining to a given installation or a given set of installation conditions. In this case, the gunned panel is obtained during the on-site installation. Such parameters as activator addition (type, amount, method of addition), conveying pressure and curing conditions (temperature, orientation of the panel) applying during the preparation of the panel are as near as possible to the same parameters pertaining to the site installation. | |
2 | This procedure applies to refractory materials that can be transported through a gunning hose after having been mixed with the total water requirement for material placement. The consistency of these materials (see 7.5) is typically such that they would be suitable for placement by casting were they not to be transported through the gunning hose and applied by spraying. |
Timeline Details |
|||||||
|
|||||||
|
|||||||
|
|||||||
Stages |
|||||
Sl. No. |
Stage | Date of Occurence | Remarks | Circulated to | Files |
1 | Generation of Document Number | 20-06-2023 | ------- | ||
2 | P-Draft Waived | 11-10-2023 | Adoption of ISO standard as new Indian Standard. | ------- | |
3 | WC Draft | 12-10-2023 | Duration : 62 Days Submitted for HOD approval |
------- | |
4 | WC Draft | 12-10-2023 | WC approved by HOD |
MTDC MTD 15, | ------- |