Document Details |
|||||
| Name of Department/Committee : | LITD 11 | ||||
|---|---|---|---|---|---|
| Document Number : | LITD 11 ( 28620) | ||||
| Document Title [English] : | Optical fibres: Part 1 measurement methods and test procedures: Sec 32 coating strippABility first Revision | ||||
| Document Title [Hindi] : | प्रकाशिक तंतु भाग 1 मापन विधियाँ और परिक्षण प्रक्रियाएँ अनुभाग 32 लेपन निर्लेपनतत्व (पहला पुनरीक्षण) | ||||
| Document Type : | Revision | ||||
| Language : | English | ||||
| Priority : | 3 | ||||
| ICS Code : | 33.180.10 | ||||
| Date of Project Approval : | 18-08-2025 | ||||
| Standards to be Revised : |
|
||||
| Standards to be Superseded : |
|
||||
Classification Details |
|
| Group : | Electronic and Telecom equipments, components and devices |
| Sub Group : | Electronic components and devices |
| Sub Sub Group : | Fibre optics & Accessories |
| Aspects : | Methods of tests |
| Risk : | None |
| Certification : | Not Certifiable |
| Short Commom Man's Title : | Optical fibres: Part 1 measurement methods and test procedures: Sec 32 coating strippABility |
| ITCHS Code : | NA |
| Ministry : |
|
| Sustainable development Goals : | |
| Degree of Equivalence : | Identical under single numbering |
| Identical/Equivalent Standards : | IS/IEC 60793-1-32:2018 |
| Organization Type: | IEC |
| Sl.No. | Synosis Points | |
| 1 | This Draft Indian Standard (first Revision) which is identical with IEC 60793-1-32: 2018 ‘Optical fibres — Optical fibres: Optical fibres: Part 1 measurement methods and test procedures: Sec 32 coating strippABility’ issued by the International Electrotechnical Commission (IEC) will be adopted by the Bureau of Indian Standards on the recommendation of Fibre Optics, Fibers, Cables and Devices Sectional Committee and approval of the Electronics and Information Technology Division Council. | |
| 2 | This part of IEC 60793 is intended primarily for testing either fibres as produced by a fibre manufacturer or subsequently overcoated (tight buffered) using various polymers. The test can be performed either on fibres as produced, or after exposure to various environments. This test applies to A1, A2, A3, B and C fibres with a nominal glass dimension of 125 μm. The object of this document is to establish uniform requirements for the mechanical characteristic – coating strippability. This test quantifies the force required to mechanically remove the protective coating from optical fibres along their longitudinal axis. | |
Timeline Details |
|||||||
|
|
|||||||
|
|||||||
|
|||||||